NSMT Model 100 Floor-standing Loudspeaker with active sub-woofer

Audio Archon is a NSMT authorized dealer located in the Chicago area.

The Model 100 is the top speaker from NSMT

What makes the 100M resolution exceptional and its performance electrifying is that the carbon fiber driver is crossover-less and covers the fundamental frequency range of  most instruments and voices from 35 Hz to 4,750 Hz. There are no crossover induced phase or frequency abnormalities to muck up the sound in the most significant part of the audio spectrum. The tweeter covers the harmonics of instruments and voices from 4,7500 Hz to 20,000 Hz. It is seamlessly integrated with the carbon fiber driver response with a 6 dB slope crossover. The subwoofer provides low bass reinforcement from 20 Hz to 200 Hz.

Special Features

Design: Acoustic suspension, time coherent, crossover-less woofer, first order crossover to tweeter, two-way with built in bandpass subwoofer
Drivers: 1&1/8 inch textile dome tweeter, 8 inch woven carbon fiber woofer, 10 inch paper cone subwoofer
Crossovers: single capacitor and resistor to the tweeter, single air core copper inductor and capacitor to the subwoofer (passive Version),
Wiring: Multi-strand copper to tweeter, woofer, and subwoofer.
Connectors: Fully insulated, gold plated five-way bi-wire/bi-amp binding  posts

Connections to amplifier via speaker level inputs.

Technical Data

Dimensions: height 44 inches; Base -14 inches wide by 14.5 inches deep; Top Panel -12 inches wide by 11 inches deep

Frequency Response: 20 Hz - 20 kHz
Sensitivity: 93 dB 1 watt/m
Rated Impedance: 8 ohms
Minimum Impedance: 4 Ohms
Recommended Power: 5 - 200 watts
Shipping Weight: 80 pounds each

Cabinet construction: sealed anti-resonant medium density CARB 2 fiber board and/or natural plywoods. The front of the cabinet is slanted 2 degrees, from the bottom to top to help align the acoustic centers of the drivers and the subwoofer output and to eliminate standing waves in the cabinet.

Standard Finishes: natural birch plywood, red birch plywood, sapele plywood, walnut plywood. Other finishes available at additional cost.

Warranty: 5-year limited warranty.

Active Bandpass Subwoofer Section

250 Watt amplifier
10 inch long-throw treated paper cone woofer
Auto-on power switch controlled by input signal
Continuously variable crossover from 40 Hz to 180 Hz at 24 dB/octave
Volume control to adjust output
Overload and thermal and fuse protection with output relay
Gold plated RCA line level input and output connectors
Removable IEC type power cord
Discrete TO-3P output devices
THD: Less than 0.05%
S/N ratio: Greater than 85dB
Power requirements: Switchable, 120/240 VAC, 50/60 Hz 
Shipping weight: 75-85 pounds each

Please feel free to contact us with any questions.
Thanks for looking!
Mike
Audio Archon
847-687-4800
[email protected]
www.audioarchon.com