Amphion Argon 3S monitors , 1-18 are the pro monitor version Argon 3E
2 way studio monitor usung a 2 Nd order time aligned waveguide tweeter
Wave guide is 6.5 inches to match the mid-Bassdriver ,and a matching 6.5 tunes rear
Passive radiator,all seas drivers, made in Finland. I removed everything the crossover is fully upgraded using worlds best Path Audio resistors ,cornel Dubilier bypass capacitors smaller caps a Jantzen lumen z, big midBass and. Filter caps aclarity Csa
I'd seen in one of your posts talking about the Borresen X3 speakers where you mentioned changing a couple of the caps. Do you mind sharing how you did this? How did you access the cross over, by removing a driver/s? Thanks for the advice/help.
You have to flux and heat up the capacitir,resistor leads near the board then it wiggles out
The traces are pretty thick ,you just have to be careful I used both boards if you are afraid
Then just cut the leads close to the capacitor leads where they come out from the body
Ofthe capacitor, and resistors after writing down their values , the Jantzen Alumen Z are excellent capacitors are fit nicely, using Duelund .01 tinned copper foil bypass caps ,
And path audio resistors , mills resistors are a much less expensive alternative . I hope this helps . I also got rid of those connectors i used WBT nextgen speaker terminals ,
And all drivers, as well as internal wire connectors use the Furutech and WBT gold over Copper slide on connectors much better then solder far better conductor better sounding.
