Audio Research DS450M 2 box Monaural amplifiers Silver.
Listing ID: lisb81c2 Classified
Listed · 592 Views
Listed · 592 Views
Time Left: None
New Retail Price:$10,000.00
$3,495.00
Buy It Now
Make Offer
| Condition | |
| Payment methods |       |
Contact seller after sale to pay viaVISA/Mastercard, American Express, Certified check, Personal check, COD or Wire Transfer | |
| Ships from | Covina, CA, 91724 |
| Ships to | United States and Canada |
| Package dimensions | 24.0" × 24.0" × 20.0" (55.0 lbs.) 24.0" × 24.0" × 20.0" (55.0 lbs.) |
| Shipping carrier | UPS |
| Shipping cost | $300.00 |
| Original accessories | Box |
 Average | Research Pricing |
Sunny Components Inc,
Tue, Wed, Thur, Fri 10.00am-6.00pm.Sat-10am-4pm Closed on Sunday and Monday.
1370 E Cypress St Ste D,E Covina CA-91724 USA
Tel: 626-966-6259. Fax: 626-966-5467. Cell: 626-975-1353.
Email: [email protected].
Store website: www.sunnyaudiovideo.com
Tue, Wed, Thur, Fri 10.00am-6.00pm.Sat-10am-4pm Closed on Sunday and Monday.
1370 E Cypress St Ste D,E Covina CA-91724 USA
Tel: 626-966-6259. Fax: 626-966-5467. Cell: 626-975-1353.
Email: [email protected].
Store website: www.sunnyaudiovideo.com
Call in and book an appointment to get a focused demonstration for all our products and purchase pick up.
Some of the finest products built in America & Europe, combined with the finest service and know how and expert setup from Electrical power to the finest Audio stands, electronics speakers turntables and streaming. We stock, install and configure Roon and MQA.
We are offering a very special Audio Research 2 box Amplifiers for sale.
This offering consists of 2 each DS450M Amplifiers in silver finish.
They are packaged in original boxes.
They will be shipped with the original 20 amp power Cord.
They also have spare fuses that are provided by Audio Research.
This is a 1 owner set of amplifiers.
This system was used in summer when my customer did not want to use tubes.
The DS450M mono amplifier adds a new level of performance and flexibility to our Definition Series of amplifiers. Providing abundant power, dynamics and control in a compact chassis, the DS450M rounds out the DS amplifier lineup.
There are several reasons to choose the DS450M over its stereo counterpart. The most important is performance-based: a monaural amp simply produces a bigger, more spacious soundstage. Also, we were able to fit a much larger power supply in the chassis. Then there is the issue of size: the DS450M is smaller and easier to situate than the hefty DS450 stereo amplifier. In addition to its reduced height, the DS450M mono is 4.15 inches (10.5 cm) shallower, allowing it to fit in a much tighter cabinet space. And, lastly, the DS450M is also perfect for multi-channel home theater systems when you only need one more powerful and dynamic amplifier channel. Rated power is 450 watts into 8 ohms.
The DS450M has the same chassis size as the DSi200 and DS225, and continues the same design philosophy of other Definition Series amplifiers. Our proprietary “hybrid Class D” all-discrete analog switching-mosfet output technology is combined with an enormous linear analog power supply, yielding tremendous speed and power delivery in a compact, cool-running chassis. This remains a distinctive Audio Research design from the ground up, forsaking the use of prepackaged “OEM” solutions common to other switching amplifiers. Each DS450M idles at only 55 watts. One major enhancement that allows a pair of DS450M’s to offer even higher performance than a DS450: the energy storage of a pair of DS450M monoblocks is 1,368 joules, an increase of 62% over the DS450. The immense power supply will jump-start the most inefficient speakers when the music demands it.
The DS450M is a fully balanced design with both XLR balanced inputs and RCA single-ended inputs. The rear panel features a dual Cardas patented speaker binding post and two 12V triggers. A 12-gauge detachable power cord with a 20A IEC connector is included. In addition to the standard all-silver version, the DS450M is also available with a black front panel, black handles, and black top cover.
The DS450M builds on the foundation of its siblings, with great resolving power, pinpoint imaging, and a musicality that is immediately involving. The enormous power supply provides an authority and sense of dynamics that are breathtaking with whatever music you choose. Whether it is used in the most refined music system or the most over-the-top video system, the DS450M will provide a level of performance and value that is startling.
Like all Audio Research products, the DS450M is made by hand in our Plymouth, Minnesota facility. Connections are hand-soldered, not press-fit nor wave-soldered. All metalwork, boards, transformers and major parts are American-made and sourced locally. We take a great deal of pride in our workmanship, and so will you.
Several speaker packages available with these amplifiers. We have DAC's, Pre-amplifiers and more.
POWER OUTPUT
450W into 8 ohms (650W into 4 ohms), 1% THD
POWER BANDWIDTH
(-3dB points) 5Hz to 45kHz into 8 ohms
FREQUENCY RESPONSE
(-3dB points at 1W) 5Hz to 45kHz into 8 ohms
INPUT SENSITIVITY
2.9V RMS for rated output (26dB Gain) single-ended or balanced
INPUT IMPEDANCE
150K ohms single-ended, 300K ohms balanced differential
OUTPUT TAPS
-
OUTPUT REGULATION
0.02dB 8 ohms loaded to open circuit
OVERALL NEGATIVE FEEDBACK
-
DAMPING FACTOR
440
DISTORTION
-
SLEW RATE
5 V/µs (20% maximum duty cycle)
RISE TIME
8.0 µs
HUM & NOISE
<300µV RMS (105 dB below rated output IHF A-weighted)
POWER SUPPLY ENERGY STORAGE
176,800 µF total 684 Joules
POWER REQUIREMENTS
100-125VAC 60Hz (200-240VAC 50Hz) 550 watts at rated output (450W into 8 ohms), 700 watts at 650W into 4 ohms, 700 watts maximum, 55 watts idle
OTHER
Output current: ~35 amps peak at protective shutdown. Output polarity: Non-inverting from single-ended input. Balanced pin 2+ (IEC-268)
DIMENSIONS
19" (48 cm) W (standard rack panel) x 5¼" (13.3 cm) H x 14¼" (36.2 cm) D (front back panel). Optional handles extend 1½" (3.3 cm) forward of the ⅜" thick front panel. Output connectors extend 1½" behind rear panel.
Call us for any and all Questions.
We are offering a very special Audio Research 2 box Amplifiers for sale.
This offering consists of 2 each DS450M Amplifiers in silver finish.
They are packaged in original boxes.
They will be shipped with the original 20 amp power Cord.
They also have spare fuses that are provided by Audio Research.
This is a 1 owner set of amplifiers.
This system was used in summer when my customer did not want to use tubes.
The DS450M mono amplifier adds a new level of performance and flexibility to our Definition Series of amplifiers. Providing abundant power, dynamics and control in a compact chassis, the DS450M rounds out the DS amplifier lineup.
There are several reasons to choose the DS450M over its stereo counterpart. The most important is performance-based: a monaural amp simply produces a bigger, more spacious soundstage. Also, we were able to fit a much larger power supply in the chassis. Then there is the issue of size: the DS450M is smaller and easier to situate than the hefty DS450 stereo amplifier. In addition to its reduced height, the DS450M mono is 4.15 inches (10.5 cm) shallower, allowing it to fit in a much tighter cabinet space. And, lastly, the DS450M is also perfect for multi-channel home theater systems when you only need one more powerful and dynamic amplifier channel. Rated power is 450 watts into 8 ohms.
The DS450M has the same chassis size as the DSi200 and DS225, and continues the same design philosophy of other Definition Series amplifiers. Our proprietary “hybrid Class D” all-discrete analog switching-mosfet output technology is combined with an enormous linear analog power supply, yielding tremendous speed and power delivery in a compact, cool-running chassis. This remains a distinctive Audio Research design from the ground up, forsaking the use of prepackaged “OEM” solutions common to other switching amplifiers. Each DS450M idles at only 55 watts. One major enhancement that allows a pair of DS450M’s to offer even higher performance than a DS450: the energy storage of a pair of DS450M monoblocks is 1,368 joules, an increase of 62% over the DS450. The immense power supply will jump-start the most inefficient speakers when the music demands it.
The DS450M is a fully balanced design with both XLR balanced inputs and RCA single-ended inputs. The rear panel features a dual Cardas patented speaker binding post and two 12V triggers. A 12-gauge detachable power cord with a 20A IEC connector is included. In addition to the standard all-silver version, the DS450M is also available with a black front panel, black handles, and black top cover.
The DS450M builds on the foundation of its siblings, with great resolving power, pinpoint imaging, and a musicality that is immediately involving. The enormous power supply provides an authority and sense of dynamics that are breathtaking with whatever music you choose. Whether it is used in the most refined music system or the most over-the-top video system, the DS450M will provide a level of performance and value that is startling.
Like all Audio Research products, the DS450M is made by hand in our Plymouth, Minnesota facility. Connections are hand-soldered, not press-fit nor wave-soldered. All metalwork, boards, transformers and major parts are American-made and sourced locally. We take a great deal of pride in our workmanship, and so will you.
Several speaker packages available with these amplifiers. We have DAC's, Pre-amplifiers and more.
POWER OUTPUT
450W into 8 ohms (650W into 4 ohms), 1% THD
POWER BANDWIDTH
(-3dB points) 5Hz to 45kHz into 8 ohms
FREQUENCY RESPONSE
(-3dB points at 1W) 5Hz to 45kHz into 8 ohms
INPUT SENSITIVITY
2.9V RMS for rated output (26dB Gain) single-ended or balanced
INPUT IMPEDANCE
150K ohms single-ended, 300K ohms balanced differential
OUTPUT TAPS
-
OUTPUT REGULATION
0.02dB 8 ohms loaded to open circuit
OVERALL NEGATIVE FEEDBACK
-
DAMPING FACTOR
440
DISTORTION
-
SLEW RATE
5 V/µs (20% maximum duty cycle)
RISE TIME
8.0 µs
HUM & NOISE
<300µV RMS (105 dB below rated output IHF A-weighted)
POWER SUPPLY ENERGY STORAGE
176,800 µF total 684 Joules
POWER REQUIREMENTS
100-125VAC 60Hz (200-240VAC 50Hz) 550 watts at rated output (450W into 8 ohms), 700 watts at 650W into 4 ohms, 700 watts maximum, 55 watts idle
OTHER
Output current: ~35 amps peak at protective shutdown. Output polarity: Non-inverting from single-ended input. Balanced pin 2+ (IEC-268)
DIMENSIONS
19" (48 cm) W (standard rack panel) x 5¼" (13.3 cm) H x 14¼" (36.2 cm) D (front back panel). Optional handles extend 1½" (3.3 cm) forward of the ⅜" thick front panel. Output connectors extend 1½" behind rear panel.
Call us for any and all Questions.
No questions have been asked about this item.
Ask the seller a public question
You must log in to ask a question.
Return Policy
Return Window
Returns are not accepted on this item.
