AkitikA GT-102

2 year old GT -102. I purchased this amp factory assembled from Akitika. This is a power amp with no volume control, there's a on off switch on the faceplate. Scratches on amp are pointed to in pictures. Works great but I have no use for this amp. Stereophile gave this amp a B rating in the power amp category. 

Will ship double boxed to USA for $ 35.00. 
will ship within 24 hours of payment.

 

Specification Summary (Original GT-102)

• Output Power: greater than 50 Watts per channel into 8 Ohms
• Small Signal Bandwidth: typically wider than 5 Hz to 100 kHz at -3 dB points
• Slew Rate (typical) 14 Volts/microsecond
• Damping Factor @ 1 kHz wrt 8 Ohms: >80
• Signal to Noise Ratio: typically 136 dB below 50 Watts into 8 Ohms, A-weighted, referred to a shorted input.
• Harmonic Distortion: typically 0.003% at 50 Watts into 8 Ohms at 1 kHz. Clipping occurs at a bit more than 60 Watts into 8 Ohms at 1 kHz.
• Intermodulation Distortion: 0.004% typical, SMPTE 4:1, 60 Hz, 7 kHz
• Separation: >90 dB at 1 kHz, >70 dB at 10 kHz
• Input Impedance: 51 K Ohms
• Sensitivity: 1 Volt RMS input produces 20.59 Volts RMS output
• Dimensions: 15" Wide x 10" Deep x 4.5" Height (includes height of the feet)
• Input Power: 120 VAC 60 Hz, IEC connector (power cord supplied)
• Input Power Fuse Rating and type: medium acting 3 Amps or 3.15 Amps, 5x20 mm
• Weight: 15.5 lbs
• Shipping Weight: 19 lbs