Very impressed, especially with the Leedh volume control. No preamp needed.
Clarisys Minuet
Just installed on 8-29-23. replaced my beloved Focal Sopra 2's.
Rotel Michi 8
Just added these 140 lb. amps. Rated for 1800 watts per 4 ohm.
JL Audio F-113 Subwoofers (4) of them.
4 F-113's
AudioQuest Niagara 7000, (2) 1200, 1000
On my 3 dedicated lines for a total of 4 AudioQuest units. I have (2)1200 for my JL subs. 2 are in the back of the room and 2 in the front.
AudioQuest Niagara Power conditioners
ADD-POWR Sorcer X4
Great conditioner!
AudioQuest Dragon High Current 20A for My Niagara 7000 & Dragon Source
Using this power cord on my AudioQuest Niagara 7000 power conditioner. Quite impressive!
Added another Dragon Source to my Lumin X1
Critical Mass Systems Center Stage CM2,2M in both the 1.0 & 1.5 size footers. Total of 6 sets being used.
I now have 6 sets under my equipment and boy are they impressive.
Clarus Crimson Bi-Wire Speaker Cable
Infigo Cables USB, Signature 2 sets XLR cables
Entreq Silver Tellus
Silver Tellus used om my digital. Plus a DIY large box used on analog and two smaller DIY boxes used on each speaker.
EtherRegen Uptone Audio
AfterDark Queen Clock and Linear power supply
Combo
WireWorld Platinum 8 Ethernet
I didn't think an ethernet cable would improve the sound much, but with cable connected to my Ether Regen input from my modem even though I am sending the output via fiber to my Lumin X1, increased the sound quality presence. Quite impressive.
Man, they are really different than what I was used to. Right now, I am trying to get some quality speaker cables for the woofer end. The ones I am using need lots of break in.
Hi @ozzy your response to my discussion on the Magico A5 prompted me to look for your system.. All I can say is WOW!!, just WOW!! what a phenomenal looking system. And that cutie little dog..
Hey Ozzy, just bought a set of Carver 350 mono’s and wanted to do the mods on them that you recommended. Can you tell me the potentiometer value so I can order the right ones from gold point? 10k… If you don’t mind sharing where to place the bypass caps in the circuit? Pictures would be nice. I saw the pictures online that shows the point to point wiring but I couldn’t tell from looking at those.
